I needed an elevated stand for my cat's lick mat, after searching on printable for a bit I couldn't find anything so I designed my own. It has a flat face of approx 22cm X 24.5cm. I've designed it to accommodate the Casper fish shaped lick mats which is on the larger side so it should be able to comfortably hold any size you might have. I added a small angle of 8 degrees for neck strain relief, so the height at the front is about 5.5cm and the back is about 8.5cm. Which is perfect for my cats which I would say are small to medium sized.

I printed this in PETG pro, standard settings with a 0.4 nozzle and 0.2mm layer height on a Bambu Lab P1S. I recommend printing this on it's side with tree supports.

I did also add some small rubber feet to prevent any sliding on hardwood floors. They're hard to see in the picture because they're clear, but I recommend picking up a set and adding them as well. You can easily find them at any hardware shop or on amazon.

Please share pictures of your make along with your cat(s) if you do decide to print this model!