Challenge Coin Holder by karb0nk0py

karb0nk0py

Household>Office

Print Profile(8)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

9.4 h

1 plate

5.0(13)

0.2mm layer, 2 walls, 15% infill

Designer

9.1 h

1 plate

5.0(4)

0.2mm layer, 2 walls, 15% infill

Designer

7.8 h

1 plate

5.0(2)

0.2mm layer, 2 walls, 15% infill

Designer

9.1 h

1 plate

5.0(1)

Click to see more

Boost

100

171

157

Released

Description

This is a Challenge Coin Holder I made for my girlfriend that could be used for other types of coins/chips, like sobriety chips, poker chips, edc coins, medals or any other item that would fit in the 5mm slots. The holder has been split into pieces so they can be painted easier. So you can do the traditional flag like I did in the preview or any color combination you'd like. I went ahead and uploaded some of the other color combinations as well. I haven't done any tuning to the print profile FYI, all settings are 100% stock and used Bambu Basic PLA.

I also made little feet to raise the back end up a little bit so there is a slight angle to the holder. They are 10mm, 15mm, 20mm. I used three on hers and worked out great.

*Note* there is a top and bottom on the feet! The top has a slight slant to it so they can be glued flat and sit flat on your deck/table/shelf!

AMS Color Slots for the 3MFs I uploaded, that way you don't have to recolor any of them.

Slot 1 / Slot 2 / Slot 3

Traditional Color -- Red / Blue / White
Black & Grey -- Black / Grey
Thin Blue Line (Law Enforcement) -- Black / White / Blue
Thin Gold Line (Dispatchers) -- Black / White / Gold
Thin Green Line (Federal Agents, Game Wardens, Park Rangers, Border Patrol) -- Black / White / Green
Thin Silver Line (Corrections Officers) -- Black / White / Silver
Thin Red Line (Fire Fighters) -- Black / White / Red
Thin White Line (Emergency Medical) -- Black / Blue / White

Comment & Rating (24)

@JF699

Print Profile

0.2mm layer, 2 walls, 15% infill

Had a smaller space to place my stand on so I remixed the original model and printed in black. Thanks for the original model, it was just what I was looking for!

@user_568113613

Print Profile

0.2mm layer, 2 walls, 15% infill

love it. came out prefect!

@user_2925160602

Print Profile

0.2mm layer, 2 walls, 15% infill

Prefect print. I created a full color print profile as well. had a ton of filament changes but the end product was worth it.

@astark436

Print Profile

0.2mm layer, 2 walls, 15% infill

I was looking at buying something to display my challenge coins and found this, turned out amazing. used burnt titanium, red/black, and white filaments.