Magnetic 3D Scanner Tracker\Marker Dots-AMS Print
Copyright Claim
Magnetic 3D Scanner Tracker\Marker Dots-AMS Print
Boost
20
36
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
32 min
1 plate
Boost
20
36
3
0
20
8
Released
Description
THIS PRINT REQUIRES AN AMS! Just a batch of 30 of one sided reusable 3d scanner marker dots. They can just be laid on your scan surface or they can be glued to disc magnets or you can put double stick tape on them. The inner white dot is 6mm the outer ring is 12mm. Dots print face down for a nicer surface finish.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
As expected. Thanks.
0
Reply
BTW These dots work fine with my Inspire scanner, that said if you wanted to increase the reflectivity you could use silk white.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld