Detergent Cup Holder
Copyright Claim
Detergent Cup Holder
Boost
7
26
4
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1 h
1 plate
Boost
7
26
4
0
23
29
Released
Description
Designed this for catching leaks from laundry detergent. Fits over a standard wire shelf (~1in between wires). I printed it on its side and had supports in the gaps for the shelf wires. So far has worked wonderfully and we don't have any more dried detergent on our washer!
Comment & Rating (4)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
worked well. thanks for posting the file!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
the lower radiused corner did not (visually) turn out the best even with the supports. chamfer instead of radius might improve it, plus could remove the need for supports there
but being in the laundry room doesn’t really matter if it’s not perfect
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed flawlessly!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
super fast and say print to solve a common issue.
(Edited)0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld