Large Rugged Box Remixed by Buzzzz

Remixed by

Buzzzz

Tools>Organizers

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

11.2 h

4 plates

4.8(17)

Boost

133

192

417

370

Released

Description

Large rugged box to store tools, spare parts, accessories, etc.

Interior dimension

247 mm x 180 mm x 120 mm (90 mm box + 30 mm lid)

It's the maximum width I could fix on Bambu's 256 mm print bed

Material used

Box: PLA

Latch: PETG

Seal: TPU

Hardware needed

Screws: (6) M4 x 45mm

Comment & Rating (25)

@amer.do

Print Profile

0.2mm layer, 2 walls, 15% infill

The design of the box is great. I printed the box in PETG, which was also successful, but the box and the lid warped a bit after cooling, as it’s a large box. With a few ribs inside, this probably wouldn’t have happened. I will print another box but in PLA as the designer recommended. The designer used real M4x45 screws for the hinges and the locking mechanism. I printed some in PETG and it works as well.

The designer has replied

@Buzzzz

Good idea for the printed screws

@analyticOne

Where did you find the 3d printed screws file?

@amer.do

Replying to @analyticOne :

Here: https://makerworld.com/en/models/70851#profileId-86384

(Edited)

@printmaject1969

Hello, great print, but you think you can move the rear hinges straight back about 2mm then you can add more material around the bolt holes to keep them from cracking?? Should NOT change the geometry ??

@printmaject1969

Print Profile

0.2mm layer, 2 walls, 15% infill

I really enjoy the Rugged, BUT 1 small issue. The rear hinges in the back ahs to little material around the threaded bolt holes??? I used Bambu PLA Marble and the holes cracked and broke 'ONLY" on the hinges!! Could you IF possible to add more material around them holes IF it will not cause issues?? I was going to TAP the holes,but NOT enough material, here are some pictures!! Other than that it turned out BEAUTIFUL!!! Love the 2 color for the LOGO!!