Poop Bucket Roof by Chris Lutz

Chris Lutz

3D Printer>3D Printer Accessories

Print Profile(3)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

0.2mm layer, 2 walls, 100% infill

Designer

55 min

1 plate

4.8(21)

0.2mm layer, 2 walls, 100% infill, different orientation

44 min

1 plate

5.0(8)

A1-Mini, 0.2mm layer, 2 walls, 100% rectilinear infill

1 h

1 plate

5.0(2)

Boost

139

323

177

Released

Description

I tried many of the highly rated poop chutes but kept running into issues with them getting backed up for various reasons. I decided to go with a ‘bucket’ that has more room instead of the smaller chute styles.

Here is my resolution to that issue. I am calling it a poop bucket roof. It helps direct the poop down into the buckets as sometime they ‘shoot’ out of the back and miss it.

It takes less than an hour to print in PLA. It fits my P1S perfectly. I have not tested with any other Bambu printers so I am unable to confirmed, but think they should work with them too. I have not had any issues so far. It uses the stock mounting holes. However, you will need longer screws. Those can be picked up at your local hardware store.

Comment & Rating (35)

@PianoReeves

Print Profile

0.2mm layer, 2 walls, 100% infill

Good print but not compatible with the default spool holder.

(Edited)

@LinkDesigns

Print Profile

0.2mm layer, 2 walls, 100% infill, different orientation

Turned out well even at ludicrous speed! Works great, but will probably be swapping it out for a full bucket soon.

@arrodd

Print Profile

0.2mm layer, 2 walls, 100% infill

Thank you for sharing.

(Edited)

@richmorris317

Perfect print and works well with the anti vibration risers I added to the P1S.

@DaveinNC

Print Profile

0.2mm layer, 2 walls, 100% infill, different orientation

worked great!!

@AlciaAlford

Print Profile

0.2mm layer, 2 walls, 100% infill

It works well. I didn't need a new screw. I used a screw to fix the heat bed during transportation.

(Edited)

@copymaster

Print Profile

0.2mm layer, 2 walls, 100% infill

Some cooling problems at the inner site of the print. But overall, nice print.

The designer has replied

@ChrisLutz

Sorry to hear. I would assume that maybe the bed was not cleaned good before printing? I printed several of these without issues along with a couple others that rated it. I would recommend giving it another try, but wipe down the plate with steel wool and alcohol. It does wonders for bed adhesion.

@copymaster

Replying to @ChrisLutz :

It's the inner site, not sticking to the build plate. Same results with different oriëntatiens.

(Edited)

@user_3388090844

Leider kein Eimer

(Edited)

@user_446337016

Print Profile

0.2mm layer, 2 walls, 100% infill

Cannot screw back into place as screw is not long enough, not sure if there’s another screw you’re meant to use or if the design is a bit too thick around the screw hole

(Edited)