After browsing some of the great riser designs, I found some were a bit bulky and would likely cause some unwanted vibrations however https://www.printables.com/@RockChewer & https://www.printables.com/@Marwyn designs were two of my favorites, so I decided to combine some of my favorite features while adding some new ones. I mainly wanted to be able to mount a small 5v LED strip at an angle for a “stadium light” approach without having to do much work after the print. I also wanted it to fit snug with my ARC enclosure from https://www.printables.com/@thrutheframe (such a wonderful design) so I slightly modified some of the accent pieces to cozy up to the riser itself. However, the accents can be optional as the riser works with the originals as well. The covers for the hexagon shaped vents are magnetic with one model of a (paintable) Bambu Lab marking and the other is a blank step file so you can add whatever you like.
3MF file only includes the main body, vent covers, and connectors. Optional gasket files and accent files available in raw files.
NOTE: You are welcome to try this with other enclosures, however it is only tested with the ARC. My main concern would be stability as it may not have anything to keep it from moving or sliding once vibrations are introduced. If you do indeed try this on another enclosure, please let me know your experience so I can share that information here. Thank you!
-6 X 3 Magnets (48 total)
-5v LED strip (If you want to use the P1Ps USB for power)
If you do not want to use a 5v LED strip, there is a cable passthrough at the rear right side of the riser for alternative power sources.
Assembly:
-Use the 4 connector pieces to connect the 4 riser pieces. (These are designed to be snug fit to improve the riser's rigidness)
-Attach your light strip to the 45-degree angle found on the inside of the riser. Careful around the 90 degree turning points. The strips are not made to make that sharp of an angle so just leave a little extra length here to be able to fluidly make the sharp turns on the riser with your LED strip. I included a picture of placement location. *Note* If you purchased the strip in the link provided, you will have some extra length, but they can be trimmed to fit however you want.
-If you printed the modified ARC accents, attach them to your enclosure but DO NOT tighten down all the way.
-Place the riser on your machine and adjust your accent pieces to “clamp” down on the riser lightly.
-Now just add your TPU gasket, power up your LEDS and place the Bambu top glass. DONE!
Print and install at your own discretion. While my designs work for me, the reality is, they may not work for you. Nature of the beast. Happy printing!