This model is created by Make My Sign
Make Your Model
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.9 h
2 plates
Boost
29
47
3
0
33
30
Released
Description
Signs were created with Make My Sign but the holder and wine rack are original designs. The sign is 180mm x 105mm with 8mm corner radius so you can swap it out for different holidays. Sign and holder each use a pair of 6mm magnets with a little shelf to help hold the sign up.
Powered by Make My Sign from MakerWorld(makerworld.com/makerlab/MakeMySign)
Documentation (1)
Bill of Materials (1)
Wine and Sign Holder BOM.xlsx
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
As a South park fan I absolutely love this and had to print it. Came out perfect too.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
only issue I have it the magnet holes are just bit small.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
very good and nice! thanks for it
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld