Command Zone Deck and damage Counter by k2thestank

k2thestank

Toys & Games>Board Games

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

4.2 h

2 plates

4.2(5)

Boost

Released

Description

Insert your commander into your choice of players Command areas and get into the action.

One will work perfectly for card with or without sleeves, while the other will accept Top Loader decks!

Easy to print individually or with a MMU, ALL STL's are multi level so you can easily color them by using the object tab or in the paint function.

Materials:

M3x4mm Screws x4
PLA or PETG

Print settings:

2 walls
10% infill
5 Top/Bottom layers
0.20mm layers
0.25mm minimum clearance

Comment & Rating (13)

@SydeShowJoe

I'll give this a 4.5 stars - I had to do some creative "remixing" to get the "casts" dial to print the letters. I basically had to select the text as a file and increase its size to 120%, with the "z" axis at 200. It fits on the dial and didnt need supports on the slight overhangs. It fits and spins. The requirement for 4mm 3M screws is optional. You can use the little beveled plastic inserts and "carefully glue" them just in the center. It will hold and still allow the dials to spin. Would have preferred a "snap" on feature, to avoid needing screws or glue; but, this is till a nice design. I have the .stl file for the casts i remixed, happy to send to the creator for use.

(Edited)

The designer has replied

@k2thestank

i can look into a few revisions. i had debated a pin idea for attachment points instead of screws just been busy on other projects i haven't had the time to revisit the design yet.

@wikitinl2

Print Profile

0.2mm layer, 2 walls, 15% infill

Other Issues:nice file, but the numbers on the "casts" dial wont print on a .4 nozzle while the numbers on the other 4 dials will.

@SydeShowJoe

hey, i have a remix i did of the casts and can share with you the .stl file i have. see my review/comments and the photo attached.

@thunderboy985

Replying to @SydeShowJoe :

can you share the remix for the cast dial with me? I have messed with it in blender and i cannot get the numbers to show up regardless of what i do to increasing their size or the Z axis.

@thunderboy985

Replying to @thunderboy985 :

I did figure it out.... you need to push the scale of the text to 120% overall then the Z axis needs to be pushed to 200 (I chose 300 because I'm a mad man) but your advice is what got me there, thank you for the help @SydeShowJoe

@user_3930446664

The casting wheel will slice properly if you go into the object section and select the text. Then split it into it's parts. This will separate all the numbers. It will then slice and print properly without any other adjustment.

(Edited)