Hygrometer Stand
Copyright Claim
Hygrometer Stand
Boost
56
121
48
Print Profile(4)
Standard
Designer
26 min
1 plate
0.16mm layer, 3 walls, 0% infill
40 min
1 plate
0.24mm layer, 3 walls, 25% infill, Textured PEI plate.
23 min
1 plate
0.6mm nozzle, 0.3mm layer, 2 walls, 10% infill
20 min
1 plate
Boost
56
121
48
0
218
219
Released
Description
Basic hygrometer stand with easy access for battery changes. This typically prints in just under an hour. Your hygrometer should snap into the opening.
This is a common hygrometer, but this is the one that I use.
The following filament was used in the pictures above:
- polymaker PolyTerra Charcoal PLA
Comment & Rating (48)
All
Sits a bit loose, assumingly because of the Hygrometer model itself. Still works as intended, but maybe I'll reprint it a bit scaled down
1
Reply
Print Profile
Standard
nice model, easy to print.
1
Reply
Perfect little low-profile stand! Fits great and securely, with easy access to the tabs to remove if needed.
1
Reply
Print Profile
Standard
great fit
1
Reply
Print Profile
Standard
Nice design, simple and easy print
(Edited)
1
Reply
Print Profile
Standard
Very nice print
1
Reply
Bambu PLA Pink Matte, Great Design!
1
Reply
Print Profile
Standard
Printed at ludicrous speed so did get a bit of stringing, but would be fine when printed at normal speed. I just got a 12 pack of these so no doubt I'll be printing more. thanks!
1
Reply
Print Profile
Standard
Very precise and beautiful print
0
Reply
Print Profile
Standard
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld