I attended an indoor R/C flying session on Sunday with my Uncle who is a keen model aircraft enthusiast and he builds his own planes for not only indoor flying but outdoor flying also.

The wood he works with is mainly Balsa wood and as some of his models are really small and he asked me if I could make him a Mitre block for precise cutting of angles etc, the slots he wanted are 0.35mm for the Razor saw he uses, of course I said I would have a go at Designing and Printing the model and this is the outcome, its a basic mitre block, the only difference being is the slot size.

I thought I would upload it just in case anyone is into the same hobby, the model has a lip to it so it can be pushed up against a bench edge to steady it when cutting.

I used support from the build base only as in the print preview photo.

Thanks for looking.