Desk USB charging station plus cable organizer

About

I created this organizer to house my USB charger, with stands for my phone and Apple Watch, and additional routed cables for charging other devices. I've also included a pencil holder attachment as an option.

• The organizer can hold a 8cm wide, 10cm long, and 3cm tall charger with space to plug in USB connectors and mains power.
• For reference, the internal usable space of the organizer box is 165mm x 105mm x 40mm tall.

Printing

The print profile I have uploaded has supports (and support blockers) set for the various parts. Print only the parts you require. If you download the raw files, please refer to my print profile for recommended support configuration.

Assembly

• Install the attachments (phone stand, watch charger stand, pen holder etc) to the organizer's lid. Start with the right most attachment, paying attention to the orientation and turning counter clockwise to lock into place.

• Put your USB charger into the organizer

• Route the USB cables you will be using into the organizer box. Coil the excess length within the organizer box before plugging the connectors into the USB charger

• Fit the organizer lid to the box, taking care to align the tab that is on the lid with the box.

• Finally cap the cable holes with the appropriate caps. There are 3 to choose from:
  • Cap for a single cable
  • Cap for two cables, on opposing sides
  • Cap for two cables, on the same side

Design and share your attachments

Three attachments are provided in my design:

1. Phone stand: this should fit most slab phones
2. Apple Watch charger stand
3. Pencil holder

If you wish to make your own attachments, for example, if you've a non-Apple watch charger, I've upload the model for the attachment base. The model can be found here: https://makerworld.com/en/u/1401660476

A like or follow will be most appreciated to help others discover this model. TYSM!

__