IDEA – Lamp Hanging version

A simple, fast print but yet a cool decorative lamp! Perfect for on a shelf, your desk or night stand. Check my profile for a standing version!

Only 1,5 hours of printing ~15 grams of plastic.

Requirements:

• 38mm tea light
• Glue
• 5x5mm cylinder magnets 3x
• White PLA
• Grey PLA (other colors possible)

Assembly:

• Push the tea light in the “Fitting”. If the tea light is to loose use some tape around the edge of the light to make the fit a bit tighter. (If you have a slightly bigger tea light, send me a message and I will give you a modified version.)
• Glue the 3 magnets in the “Fitting”. Make sure that the poles of the magnet point in the same direction.
• Connect the “Bulb” & the “fitting” WITHOUT GLUE!
• Done! (Don’t forget to leave a picture of your results!)