M12 Ratchet Direction Knob
Copyright Claim
M12 Ratchet Direction Knob
Boost
23
64
16
Print Profile(1)
0.2mm layer, 2 walls, 50% infill
Designer
17 min
1 plate
Boost
23
64
16
0
106
109
Released
Description
Magnetic knob that clips onto milwaukee M12 cordless ratchet. Was modeled off of a 3/8" fuel m12 ratchet unknown if other milwaukee ratchets share same dimensions.
Allows for easy direction changes especially when wearing gloves.
Requires two, 6mm x 3mm neodymium magnets.
Comment & Rating (16)
All
Print Profile
0.2mm layer, 2 walls, 50% infill
Haven’t added the magnets but seems to fit and work
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
printed abs, turned out great
1
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
Print was tiny bit too big in diameter. Hangs on the outside edges making it difficult too turn.
1
Reply
great model!
1
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
works
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
needed a little fitting after printing
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
works on the 1/2” ratchet as well.
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
Works great
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
never use my ratchet again without this knob, thanks!!
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld