Made to be printed face down on a textured plate, giving it a nice top finish.

These are designed to be used with a 2mm thick, 100mm diameter cork coaster with adhesive backing. I used these ones:

https://www.amazon.ca/dp/B08XZ4VM36?psc=1&ref=ppx_yo2ov_dt_b_product_details

I print these as a set of 4 and have included a holder as well. For the bottom of the holder I use these rubber stops:

https://www.amazon.ca/dp/B093DHDM8F?psc=1&ref=ppx_yo2ov_dt_b_product_details

Both the cork and the rubber stops give the coasters a nice feel, and help to prevent any sliding around.

Main print settings:

Layer height: 0.16

Infill: 25% (this is to ensure a smooth backing)

Infill Pattern: Gyroid

Infill/wall overlap: 60%

***If using the above cork backings, please ensure to scale X & Y to 100mm ONLY. Do not scale Z***