The sign tells it all :-)

I designed 5 versions, i named the print profiles after the following characteristics:

• One with text only, flush text, AMS needed
• One with text only, protruding text, without AMS
• One with text and crazy face with crooked eyes, AMS needed
• One with text and crazy face with crooked teeth, AMS needed
• One with text and crazy round face, AMS needed

Print instructions:

• layer height 0,20mm
• 2 wall loops
• top/bottom shells 4 layers
• top/bottom shell thickness 0,80mm
• sparse infill 10%
• sparse infill pattern “gyroid”

Before printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.

Before printing, make sure your build plate has a decent adhesion. Aftermarket plates like the ones from Alibaba haven’t good adhesion. Curling will probably occur if you don’t use original build plates! Bad build plate adhesion is not related to the model or the design!