Hello everyone!

This is my personal gift to my girlfriend for this valetine's day, I' m here to share it with you all! (she's gonna kill me for this xD)

It's a chocolate dispenser build for ferrero rocher and baci perugina BonBon. (you can also use different type of chocolate, but dimension must be under 34 mm high and under 40mm large). It takes me a lot of time design, test and PLA waste to have a nice product.

The two doors have separeted box, so you can have 2 type of chocolate, it can contain around 4 BonBon per side. You can refill putting the box upside down and using the door or, If you want, opening the cover with two finger across the doors to make lever.

The parts are easy to print, no supports or brim needed. For my project i used red and white PLA + from sunlu. Just print and build together without tools or screws.

Instructions: In the Heart box put the two doors in the pin in the “close” position, (if you want) put chocolate inside like the photo, then close with the Heart cover paying attetion to the pin for the doors. With hands make pressure to close the cover. Put the box in the Table support and with a finger open the side doors using the hole, that' s all.

My print profile are tested for p1p.

Hope you'll enjoy mi creation. Happy Valetine's day to everyone!