Harry Potter Magic Lightbox
Copyright Claim
Harry Potter Magic Lightbox
Boost
12
23
4
GIF
GIF
Print Profile(1)
V1 (HP Magic Lightbox)
Designer
4.7 h
4 plates
Boost
12
23
4
0
27
35
Released
Description
When the lightbox is turned on, Harry Potter's patronus is revealed.
I printed the lithograph in Ice Blue PLA Matte. On the back it has 2 holes to hang it on the wall, or you can place it flat. No AMS required (only 1 filament change on the front artwork, between layer 3 and 4).
These gifs concern another creation of mine but the procedure is the same (check my Harry Potter Collection!)
Assembly instructions
Final result (Ice Blue PLA Matte version)
Lightbox Desk Stand
If you want to hang the lightbox on your desk or shelf, try my Lightbox Desk Stand.
Commercial license
Do you want to sell prints of this model? You can purchase commercial licensing for this model by joining the Commercial License in my Patreon.
Comment & Rating (4)
All
Print Profile
V1 (HP Magic Lightbox)
awesome design🤪
somehow i messed up the size of the blue plate so have to print that again🤪😂
The designer has replied
1
Reply
thanks you 💞
0
Reply
Print Profile
V1 (HP Magic Lightbox)
printed out with a perfect fit. Great quality print profile. My only question is what’s the best way to keep the tiles inside the frame? I used a hot glue gun on the back to keep them pressed against the front. Thank you for a great light box!
(Edited)
The designer has replied
0
Reply
Hi, thank you for the feedback. I use some glue too, or 4 little strip of transparent scotch tape :-)
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld