Custom Yeti lid Sliders! Remix from a plain Yeti replacement lid I found on another site, however I made significant changes to correct dimensions (it was not the proper side, too small for lid track, cited magnets didn’t fit in the recess, etc). So I cleaned it all up, ensure a PERFECT Magnet fit (see source for magnets I found on Amazon below, but any round magnet that measures a true 8mm x 3mm should fit fine).

Print Details:

Use 8mmx3mm Magnets:

Grtard 50 Pack 8 × 3 mm Magnets for Crafts, Small Magnets, Round Magnets, Magnets for Fridge, DIY, Building, Crafts and Kitchen Cabinet, Office Magnets: Amazon.com: Industrial & Scientific

Pause at layer 30 to allow magnet install (ensure correct direction to attract towards lid, gentle push is all that is required, no glue, perfect snug fit!)

Adaptive layer heights

No supports

Painted - 3 Color (you can simply use this profile and select a single filament for the slider if you would prefer one color print and hand paint it yourself).

.16mm layer height

Iron – All top surfaces

15% Infill

Gyroid

No brim and no supports

Be sure to check out my other uploads as I have created lids for a variety of Jeep models and other brands!