Simple card wallet
Simple card wallet
Print Profile(1)
Description
Here is a fairly simple card wallet design which utilises a leaf spring to secure the cards in place. It can store 6 or 7 normal bank cards, or a similar number of business cards that are 85x54mm max.
0.4mm nozzle
0.2mm layer height
The leaf spring should ideally be printed using PETG although PLA works fine, and I strongly advise using a brim to secure it in place during printing.
The two case halves can be printed in any material and will need a little bit of superglue to hold them together, I recommend the gel type.
Supports aren't required.
Comment & Rating (1)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
