Magnet applicator by peteb

peteb

Tools>Other Tools

GIF

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

52 min

1 plate

4.9(20)

Boost

180

187

105

Released

Description

Opposite polarity magnet applicators. 8mm x 2mm, I glued in magnets of opposite polarity to easily pick up magnets and press them into your builds, ensuring the correct polarity.

magnet

applicator

magnet dispenser

Comment & Rating (28)

@lion7718

Print Profile

0.2mm layer, 2 walls, 15% infill

I usually don't rate a profile if I make a lot of changes in the settings, but I'll write this one. The only real issue I have with this print is I think the magnets should be in a little deeper. I don't think the side of the magnets should be sticking out at all, just the surface... JMO

(Edited)

The designer has replied

@peteb1414

I needed them to stick out to make sure they press the other magnet in all the way. Thanks though!

(Edited)

@lion7718

Replying to @peteb1414 :

Ok, I was thinking about just getting them started...maybe half way...then pushing them in from there.

@unky

Print Profile

0.2mm layer, 2 walls, 15% infill

@grantmdavies

I'm about to print the 8mm, would you share the model or have a 6mm version ? I hate installing magnets and this looks like ag great idea :)

The designer has replied

@peteb1414

There are a few 6mm versions included.

@grantmdavies

Replying to @peteb1414 :

oops sorry, yes looking for 10mm

@user_937846287

Any chance we can get these in 3x2 and 2x2 magnet sizes?

The designer has replied

@peteb1414

I can make a smaller varient.. but For the applicator you can probably just scale it right in bambu studio. This is more just for picking up magnets with uniform polarity so size isn't a huge deal. But I'll upload a smaller version today.

@user_3102700062

Print Profile

0.2mm layer, 2 walls, 15% infill

HANDY PRINT