polygon elephant pot vase
Copyright Claim
polygon elephant pot vase
Boost
197
342
37
Print Profile(1)
Easy print (0.16mm layer, 2 walls, 15% infill)
2.8 h
1 plate
Boost
197
342
37
1
632
312
Released
Comment & Rating (37)
All
Moi, imprimé à l'endroit, meilleur résultat. Avec couche adaptative juste sur le dessus. En blanc taille original, en noir agrandi.
0
Reply
Print Profile
Easy print (0.16mm layer, 2 walls, 15% infill)
like a other comment, the top is not really nice, but i like it. thank you for your work. if you put a flower/plant in it, no one will See it 😁 ps printed with a1 mini
0
Reply
Print Profile
Easy print (0.16mm layer, 2 walls, 15% infill)
Quite tricky to print.
0
Reply
Print Profile
Easy print (0.16mm layer, 2 walls, 15% infill)
0
Reply
Print Profile
Easy print (0.16mm layer, 2 walls, 15% infill)
Support Issue:Print with petg the supports are too strong!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
A bit smaller than expected, but overall a smooth print. Maybe make the print profile AMS compatible so the supports can be made of the support filament.
The designer has replied
1
Reply
thank you for the notes 💪 will do
0
Reply
Print Profile
Easy print (0.16mm layer, 2 walls, 15% infill)
sadly the top looks a mess as supports were not great
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Couldn't print higher than the tusks because they were jumping off the supports.
Probably a bad setting but I did 4 triés.
The designer has replied
0
Reply
Please try the "Easy print profile"
0
Reply
very nice model
The designer has replied
0
Reply
thanks you
0
Reply
Print Profile
Easy print (0.16mm layer, 2 walls, 15% infill)
Cool model, but the finish is not so great ( the places where the support was added do not look clean)
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld