Michael Jordan “23” Lithophane Lightbox. I have 3 panels available for this light box. 1 High Definition Lithophane that is 8 Color, 1 CMYK Lithophane that is 4 Color. 1 Hueforge Lithophane that is 3 color.

Notes:

the brighter the LED lights used the better, on these I used a Cob Led light strip in 6000K color temperature along the back perimeter and it looks fantastic with the light on, even better in the dark, really pops.

When printing the Frame you need to remove the calibration print lines, these use most of the plate size. you might get some errors that say the print tower is too close, just ignore them, they are close but won't interfere with anything or hit.

This is a 3 part print, Print plate 1 (Box Frame) and Plate 2 (Back Cover) from profile 1, Select the Lithophane you want (Profile 2 is the 8 Color, Profile 3 is the 4 Color Lithophane, Profile 4 is the Hueforge Lithophane).

Profile 1: Lightbox Frame and Back Deflector (1 plate each). I suggest using a PEI plate and print face down, No brim is needed, but make sure you have a freshly clean PEI plate. The back has a white reflector build into it. the parts are already oriented properly in the files.

Profile 2: High Definition 8 Color Lithophane Front panels. I printed on PEI plate I used the bambu CMYK bundle plus 4 other colors for this print. there is a negative part over the lithophane panel that will trim and leave a lip on the lithophane so it'll fit in the frame properly, it's tight but fits perfectly. just go slow when pushing it in. add a little superglue around the edge on the back from the inside. (See Colors Used Below)

Profile 3: Lower Definition 4 Color Lithophane Front panesl. I printed on PEI plate. there is a negative part over the lithophane panel that will trim and leave a lip on the lithophane so it'll fit in the frame properly, it's tight but fits perfectly. just go slow when pushing it in. add a little superglue around the edge on the back from the inside. (See Colors Used Below)

Profile 3: Lower Definition 4 Color Lithophane front panels. I printed on PEI plate. there is a negative part over the lithophane panel that will trim and leave a lip on the lithophane so it'll fit in the frame properly, it's tight but fits perfectly. just go slow when pushing it in. add a little superglue around the edge on the back from the inside. (See Colors Used Below)

These are the Colors I used for the High Def 8 colors profile.

Bambu Basic Jade White

Bambu Basic Magenta

Bambu Basic Cyan

Bambu Basic Yellow

Bambu Basic Beige

Bambu Matte Ice Blue

Bambu Matte Sakura Pink

Bambu Basic Black

These are the Colors I used for the Lower Def 4 colors profile.

Bambu Basic Jade White

Bambu Basic Magenta

Bambu Basic Cyan

Bambu Basic Yellow

These are the Colors I used for the Hueforge and the layer setting information.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA+ Sunlu White Transmission Distance: 5.1
PLA+ Sunlu Red Transmission Distance: 6
PLA+ Sunlu Silver Transmission Distance: 2
PLA+ Sunlu White Transmission Distance: 5.1

Swap Instructions:
Start with White
At layer #9 (0.8mm) swap to Red
At layer #14 (1.2mm) swap to Silver
At layer #20 (1.68mm) swap to White for the rest.