Modular Mosspole 60MM for all your climbing houseplants (Fill with sphagnum mos)
Modular Mosspole 60MM for all your climbing houseplants (Fill with sphagnum mos)
Boost
50
81
10
Print Profile(1)
Full set mosspole parts - 0.24mm layer, 2 walls, 20% infill
Designer
6.9 h
1 plate
Boost
50
81
10
2
125
72
Released
Description
A 3D printable mosspole that can be filled with sphagnum mos.
It exists of 3 pieces.
1. Mosspole with open structure, for more aerea for plants to grow in
2. Groundpin
3. Top cap
More mosspole pieces can be printed to extend the mosspole!
This one too big? Check my 40MM mosspole here:
https://makerworld.com/en/models/99187
NOT FOR COMMERCIAL USE!!
Comment & Rating (10)
All
Print Profile
Full set mosspole parts - 0.24mm layer, 2 walls, 20% infill
1
Reply
This is the best moss pole I've printed so far
The designer has replied
0
Reply
Thanks!!
0
Reply
Boosted
Print Profile
Full set mosspole parts - 0.24mm layer, 2 walls, 20% infill
hatte etwas Stringing sonst war es gut
0
Reply
Boosted
Hello, I really like what you did! can you make a variation of the model with a diameter of 100 mm? please, that would be great! thanks in advance.
0
Reply
Print Profile
Full set mosspole parts - 0.24mm layer, 2 walls, 20% infill
0
Reply
Print Profile
Full set mosspole parts - 0.24mm layer, 2 walls, 20% infill
(Edited)
0
Reply
Print Profile
Full set mosspole parts - 0.24mm layer, 2 walls, 20% infill
0
Reply
Print Profile
Full set mosspole parts - 0.24mm layer, 2 walls, 20% infill
0
Reply
Print Profile
Full set mosspole parts - 0.24mm layer, 2 walls, 20% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld