E61 (58 mm) style portafilter holder for Timemore Sculptor coffee grinders. Should work across both 064 and 078 series. Tested with the Decent portafilter, but should work with any E61 style portafilter as the lugs are usually similar.

Versions:
- 10x3 mm or 12x3 mm magnets
- 1 or 2x magnets - for more satisfying magnetism
- Shorter and taller (+5 mm) height - to suit different funnel lengths

Parts needed:
- 1-2x magnets
- (Optional) Super glue

Printing instructions:
- Resolution: any
- Infill: 15% is enough
- Supports: no

Assembly instructions:
- Test the magnet polarity against the grinder to ensure they attract to the base
- Press fit or super glue the magnet into the underside of the print. If you made a mistake with the polarity, use a thin flat screwdriver to pry out the magnet via the groove leading into the magnet hole

Notes: 
- Designed for 10x3 mm and 12x3 mm (diameter x height) magnets as they are what I had available. If you have another magnet size you would like, feel free to request in the comments
- I use the taller version with the MHW3Bomber funnel, which is around 1.8 cm tall
- Ideally printed in a more temperature-resistant material like ABS, ASA or PETG as pre-heated portafilters can get quite hot. Realistically, I have not had issues with PLA+ however
- The overhang on the underside is only 53 degrees, so should be easily printed by most printers without support