Free on Makerworld for a Limited Time Only.
Please click a LIKE on my product if you like it. Thank you, I will greatly appreciate it. Cheers!
For your indoor and outdoor uses, anytime you need it you will have it beside you! So much uses for many occasions for this model. Use it, Flick it whenever you need it.
Note: After printing, make a light push at the bottom of the palm to eject the fingers out of the tiny support at the bottom.
Use it when you are driving, when you are at work or even at a party. Extended version of finger to help you express your emotion, just Flick it whenever you need it.
The inital few uses may be a little hard to get the finger to extend fully but after a few times it will be working great.
Note: After printing, make a light push at the bottom of the palm to eject All the finger and shell out of the tiny support at the bottom.\
3MF is generated by Bambu Studio and model have been tested on Bambu printers. If you are using another brand please makes sure the following settings is made
Seam : Random
Wall Generator : Arachne
Supports : Enabled
Suggested Support : Tree Slim
Layer Height : 0.20
Speed : Adjust according if you see fusing of the fingers then lower the wall speed.
Brim : If you are having problem with adhesion use gluestick or Hairspray please do not use a brim and please watch the first layers as the bridge above the lower collapsing parts is built and Use glue stick if you have adhesion problems.
Do make sure you don't have an elephant foot in the first layers.
Scenerio 1 : If the finger wobbles:
Use glue / make sure your adhesion is good
lower the speed of the print
Enable z-hop if necessary
Check Z height
Scenerio 2: if walls get fused:
reduce flow / width of first layers
make sure you don't have an elephant foot
Randomize your Seam