No Print Profile yet. Add one to earn points.
MOD head for Flying Bear Ghost 5 with 2 blower fans 4010 for better cooling of the extruded material possibility of mounting support for the installation of BLTouch
Fits original Flying Bear Hotend and PCB
Fanducts optimized for correct and efficient cooling of the material The project was designed to be printed without the use of supports (excluding fanducts)
________________________
Purchase list necessary for the correct assembly of the head:
[2x] blower fan 4010 (recommended Gdstime model: 24V Ball 12000RPM)
DIN 7380 screws
[4x] M2x5
[4x] M2x10
[2x] M2.5x14
DIN 7991 screws
[1x] M2x16
[2x] M2x6 (only for model without BLTouch)
[2x] M2x8 (only for model with BLTouch)
[2x] M3x8 (only for model with BLTouch)
[2x] M3 nuts (only for model with BLTouch)
________________________
Screws removed from the original head:
DIN 912 [2x] M3x5
[2x] M3x10
DIN7380
[2x] M3x15
________________________
Tools needed:
Allen Wrench 2 [included with Ghost 5 printer]
Allen key 2.5 [included with Ghost 5 printer]
Spade wrench 5,5 [included with Ghost 5 printer] - (only for model with BLTouch)
ATTENTION: the screws are installed on plastic, so DO NOT OVER-TIGHTEN THE SCREWS
contact me for any doubts and/or problems during installation constructive criticisms are welcome
________________________________________________________________________________________________
Testa MOD per Flying Bear Ghost 5 con 2 ventole blower 4010 per un miglior raffreddamento del materiale estruso
possibilità di montare supporto per l'installazione di BLTouch
Monta Hotend e PCB originali Flying Bear
Fanduct ottimizzate per un corretto ed efficiente raffreddamento del materiale
Il progetto è stato pensato per essere stampato senza l'uso dei supporti (fanduct escluse)
________________________
Lista acquisti necessarie per il corretto assemblaggio della testa:
[2x] ventola blower 4010 (consigliate Gdstime modello: 24V Ball 12000RPM)
Viti DIN 7380
[4x] M2x5
[4x] M2x10
[2x] M2,5x14
Viti DIN 7991
[1x] M2x16
[2x] M2x6 (solo per modello senza BLTouch)
[2x] M2x8 (solo per modello con BLTouch)
[2x] M3x8 (solo per modello con BLTouch)
[2x] Dadi M3 (solo per modello con BLTouch)
________________________
Viti smontate dalla testa originale:
DIN7380
[2x] M3x15
________________________
Strumenti necessari:
Chiave a brugola 2 [inclusa con stampante Ghost 5]
Chiave a brugola 2,5 [inclusa con stampante Ghost 5]
Chiave a forca 5,5 [inclusa con stampante Ghost 5] (solo per modello con BLTouch)
ATTENZIONE:
le viti sono installate su plastica, quindi NON SERRARE TROPPO LE VITI
contattatemi per qualsiasi dubbio e/o problema durante l'installazione
critiche costruttive sono ben accette