Simple pig panel and mounting pegs, compatible with Ikea Skadis pegboard.

Included are long and short mounting pegs. Long pegs may be used to offset the printed panel from your Skadis, allowing other attachments to still be used. Short pegs hold the printed panel closer to the Skadis, and may not allow other items to be hung from the panel.

Due to the variability in Skadis holes, and 3d printing in general, you may wish to print a few extra pegs. Sometimes one (side) will be too tight for either the Skadis or the printed panel. I use pliers to push in and remove the pegs when needed. Pegs do not need support when printing, but there is a string or two on the underside, usually, that can just be nipped off.

Pig is apx 210mm wide, but I have also included a smaller version, when tilted, is about 160mmx160mm - which should fit on A1 Mini.. Using the PEI Hot Plate and no glue, pegs stick fine to the plate. But you may want to use a brim on the pegs if using a cold plate or they don't want to stick for you.

Note on the front of the big pigs nose, on one side, a section of layers are missing, strange. Not sure what happened, but plan to use the ‘bottom’ side as the side you see, or there's a faint shadow line. I'll include in the pics.

The edges aren't as smooth as I'd like, Probably wouldn't notice with darker filament and lower lighting, again, see pic for details.

Otherwise a cute little print.

Enjoy,

HL