BentoBox Cable Guide Clip

• It allows you to organise and easily clip the cable in place for the BentoBox; it can also be just as easily unclipped and moved out of the way when not needed.
• This clip is compatible with P1P/P1S/X1C.
• I can only recommend the profiles I created (“Designer” print profile) for the best results.
• Print using a filament that can withstand high temperatures (NOT PLA!), I used ABS, however, PETG should work just fine.
• The channel width is 5 mm, you do not need a low gauge (thick) cable for this (the fans consume around 1.5W).
• You can use any connector you prefer inside the BentoBox, i'm using these 2-pin JST connectors: https://a.aliexpress.com/_ExVDHVB

1. Importing:

Import the 3MF file into the slicer and make sure the selected settings are correct (video below). I have already set the correct settings for the 3MF file, but it is a good practice to verify, and you still have to select your printer if it's not a P1S.

2. Post-processing:

Pull apart the brim and the small support.

3. Installation:

Glue or otherwise adhere the cable inside the guide clip, and then clip it to the bottom of the printer's leadscrew cutout. Install the clip first and then place the BentoBox, as that'd help hold the clip in place.

Thank you for printing, please provide feedback and share your results! 😄