This is the “Magnet Dispenser” designed by me.

It can store 5 different magnet sizes. You also need the push rod so you can push the magnets out of the dispenser.

Magnet Diameters:

• 6mm
• 8mm
• 10mm
• 12mm
• 15mm

Standard Dimensions:

• HxLxW: 64.5x65.4x19.6mm
• push rod length: 75.4mm

Settings:

• layer height: 0.2mm
• line width: 0.42mm
• wall loops: 2
• infill: your own choice
• how to print: look at the pictures ;)
• supports: yes! (for the corpus)

NOTE:

As you can see in the last picture, there are recesses for magnets so that the stored magnets hold better in the dispenser. Make sure to stop the print in the slicer before these recesses are closed and insert the magnets before resuming the print (For best result: glue them in before resuming!).

Feel free to upload your Makes!