Tamiya Screwdriver Case for "Tamiya 74023"
Copyright Claim
Tamiya Screwdriver Case for "Tamiya 74023"
Boost
17
14
4
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
10.2 h
2 plates
Boost
17
14
4
0
29
5
Released
Description
This is one of the oldest screwdriver sets I own, and the tools are still holding up well.
However, the thin plastic case recently broke, so I designed a new case for it.
All you need is 8 M3x20 screws and 8 M3 nuts for the mechanism.
A piece of TPU can be inserted as a seal, but that is optional.
Comment & Rating (4)
All
had to sand down the corners near the hinges as they pinch too tightly, if you get a chance, would be nice to round or chamfer these corners.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
love it, one suggestion, the holes for the screwdrivers seem a bit tight, could have a tad bit more tolerance there, I am able to still fit them in but a couple are quite tight.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld