Mario based mushroom character. Assembles and needs some dabs of glue. Hat screws off to make secret storage area for small things.

Plates are separated into the colours, but i have provided some other versions on a legacy plate.

This is a remix of two items

@dumesnilcedri_195452 model which had the discs missing on the hat, and the centre piece for construction
 

https://www.printables.com/model/103090-toad-assemble

and the other bit which i used the head and body for was from

@3DPrinty

https://www.printables.com/model/409598-simple-twist-open-mushroom

The colours can be painted and i printed everything without supports but i recommend you put a brim on the waistcoat braid and the arms which should not be printed more than 2 at a time or you're asking for spaghetti. Parts need a dab of glue to fix, the head needs a big bit of glue to assembled base.

do not glue head till the body is completely assembled

assembly order.

start with the bodySkin piece and clip the waistcoatDotCol into it and then put rest it on the BaseWhite.

clip the waistcoatbraidyellow into the waistcoatcol and thats the body assembled.

glue the feet into the Basewhite, taking note that the feet have a left and right front and back orientation and dont just go in anyold how.

on the head, same with the eyes if you've printed separate eyes, these are the same but have a particular way round so try them in before you glue.

the neckPin needs a dab of glue to Glue it to the head with the flat bit facing forward the same as the eyes

put the coloured dots into the hat with a dab of glue then screw on the head. push the pin through the body with a dab of glue then add the arms.

best glue to use is mitre bond or two part superglue.