SODA CAN DISPENCER

_______________________________________________

About:

With this soda can dispenser you can print in one piece, no supports needed. You can load in up to SIX cans from the top or front. Because of its size it can be placed anywhere! In your fridge, on your counter, on the table, on your desk and even next to your Bambu printer! Enjoy.

____________________________________________

Steps To Print:

1. If you use the 3mf all settings will be set if not you can use the settings listed below.

____________________________________________

Dimensions + Print Time + Filament Used:

• 225mm Long (9 inch)
• 125mm Wide (5 inch)
• 135mm Tall (~5 inch)
• 240g of filament used
• 4 hour print time

____________________________________________

Settings:

• .28mm Layer Height
• Top Shell Layers: 0
• Bottom Shell Layers: 0
• Wall Line Count: 2
• Infill Density: 20%
• Infill Pattern: Triangles (You can use what you think looks cool)

__________________________________________________

Extra:

~~If you want to make your can dispenser unique then change the infill pattern to get a different shaped infill

More Cool Prints: mwiller | Published - MakerWorld