I was able to get my hands on Samurai Sword and wanted a way to display it. However, I did not find a design which suited my needs.

I have designed two version of my samurai sword holder using Inventor;

• Open top: Just as its name implies, this design allows you to simple insert the sword from the top.

• Closed top: This design allows you to "lock" the sword in place. I don't want anyone, for whatever purpose, to pick up the sword and do whatever they want with it. Thus, with this design, you insert your sword from the side.

I printed my design twice using a .3mm layer height with a 20% infill. In the future I do plan on sanding it down but I expect .2mm layer height would look even better.

• I had planned to use the closed top on the sword handle and the open top for the sword sleeve but I did not take into account the the end of the sword had thicker parts. Thus I am using them in reverse.

The inner section has a 11 degree angle because my sword has a curve to it. Thus, I do not know if it will work with straight swords.

• If you want this design for a straight sword, just PM me and I will edit the design and upload it

• I do not plan to make any aditional edits to my design but I think I would need to raise the overall height to more than 4''

Dimensions;

• 2'' wide 2'' depth 3.5'' high - The inner cut out is 1'' wide

Hopefully, this helps you to adjust the ratio to fit your needs

Double sided tape - I could design a base for this but for the time being, I think I will simply use tape to secure it to the surface.

• My intention is to show off my sword on a flat surface, thus I plan to put the tape on the very bottom. I am using cheap tape, I expect that not a lot of force will be placed onto the base.

I guess that if you use command strips or something similar you could place your sword on the wall. I have not tried it, thus I can't say if it would work or not.

I am the owner of https://www.neocrisis.com/