3d miniature of Minneapolis, Minnesota!

Model created in Blender using the Blosm addon.

Check out my collection of other miniature cities: https://makerworld.com/en/u/1935755220/collections/146964

Printing & Slicing Details

This model was designed to be printed with a 0.4mm nozzle and 0.16mm layer heights.

Try using a 0.2mm nozzle (0.08mm layer heights) or scaling up for even finer detail!

Note: If roads or other small details disappear after slicing, try lowering the extrusion/line width of external perimeters (outer walls) closer to 0.4mm OR use Arachne walls (can also enable “Detect Thin Walls”).

The included “Designer Profile” should have the above settings pre-applied and is ready to slice & print!

Filament used in photos: Sunlu Matte White (miniature), Bambu Matte Charcoal/Black (frame), Sunlu Sky Blue (water)

Framing Details

This model measures almost exactly 6.7in by 4.7in (170.5mm X 119.5mm) and should fit most 5x7 frames (assuming frame lip/overlap is around a quarter inch). Feel free to change the scale/size of the model(s) to meet your needs.

Personally I use these cheap frames from Amazon: https://www.amazon.com/dp/B0C8HY7YSQ

And blue printer paper: https://www.amazon.com/dp/B00006IDQT

I also included a fully printable frame (including a 1mm thick water plate) designed to fit all my miniature cities.

A frame is not required! This model looks great by itself and can be displayed almost anywhere.

See my Patreon for a commercial license, early downloads, polls towards future models, and more!