A layer height of 0.16 mm is required so that no fitting problems occur. If you have problems after printing there is a problem solving section at the main project page and extra customized models (“Troubleshooting (versions) for the standard edition”). Have fun!

Purge deflector required: Purge deflector(s)

I recommend to use an updated purge deflector version from at least 28.01.24.

Standard basket:

• 52 x 100 x 25 (mm)

Deeper Standard basket:

• 52 x 100 x 50 (mm)
• Slightly more volume than the XL basket, but deeper, so you can't put another basket underneath it

Thinner Standard basket:

• 49 x 100 x 25 (mm)
• If your basket is too close to the print plate this can fix it (this problem only occurs on the A1 mini). But I recommend to make sure you print with a layer height of 0.16 mm, dry your filament and make a new flow dynamics calibration and retry the standard basket.

XL basket:

• 52 x 180 x 25 (mm)
• Slightly less volume than the deeper standard basket, but an additional basket can be placed underneath.

XXL basket:

• 52 x 180 x 50 (mm)

Monster basket:

• Twice as big as the XXL basket
• Thanks @kemortso for testing
• His print profile with the green “Monster Basket” lettering: https://makerworld.com/en/models/169309#profileId-185916
• It's also in the raw files of this project (without the “Monster Basket” lettering), don't forget to print with 0.16 mm layer height.

A basket that fits under the mini pms

• Link: https://makerworld.com/en/models/375011#profileId-274943

Remix a basket:

• I uploaded the standard basket as a step file in case you want to create your own basket version.
• Remixing means bigger changes, not just adding a logo, have fun!

If you are not printing with a print profile:

print without support, tolerances are designed for a layer height of 0.16mm and PLA, but other layer heights and filaments can also work well.

Vibration noise information:

You can use the printable TPU mat, a piece of rubber, folded paper or fabric to virtually eliminate vibration noise from the poop in the basket, I used some adhesive strips under the piece to attach it. When printing with specific sideways movements, a vibrating noise can occur when the poop lightly touches the side wall. This is least likely to happen with a rubber base, alternatively the wall can also be covered with the aforementioned pieces.

How to print TPU mats and TPU inserts with walls:

• You can use the provided print profile or edit your own
• 0.16mm layer hight than edit the strength section:
  • 6 Walls (you can play with that, one loop should be 0.16mm wide)
  • 0 (zero) Top shell layers
  • 6 bottom shell layers (you can play with that, one layer is 0.16mm high, so 6 layers are 0.96mm high)
  • Sparse infill density 10% Honeycomb (you can play with both settings, maybe 15% Gyroid with only 4 bottom shell layers is more silent)

If you like my work, please feel free to support it with a small tip, I can never have enough filament and good coffee to help me with prototyping: https://www.buymeacoffee.com/dubios or https://ko-fi.com/dubios

Check out my other models!: https://makerworld.com/en/u/2166054501