This is a Holder for drying reusable silica gel in a Sunlu S2 Filament Dryer. It is designed for reusable Silica Gel with diameter 2mm-4mm, for example this:
Print 2 Plates, 1 lid and 1 tub.
Assembly:
Both plates are printed with 3 assembly sticks, which fit into the 3 holes on each side of the tub. Take the first plate press the 3 assembly sticks into the 3 tub holes, to combine the pieces. Repeat on the other side. For better stability and fit apply some glue to the contact area of plate and tub.
You also have to glue 4x2mm magnets in to the holes of the lid and the tub.
There is also a spout for safer handling of the silica gel:
https://makerworld.com/en/models/165620#profileId-181852
There is also a Funnel for safer handling of the silica gel:
https://makerworld.com/en/models/169542#profileId-186161
There is also a Silica Gel holder with wallholder for your dry box:
https://makerworld.com/en/models/200328#profileId-220783
Version 2 released 02.2024:
Changed the alignment sticks to shorter alignment nubs. The alignment sticks tend to break too easy while assembly. Shorter alignment nubs should prevent breaking.
Print Option:
Bambu Lab PETG
15% Infill
If you have any questions, feel free to ask.