IDEA – Lamp Standing version

A simple, fast print but yet a cool decorative lamp! Perfect for on a shelf, your desk or night stand. Check my profile for a hanging version with magnets!

Only 1,5 hours of printing ~15 grams of plastic.

Requirements:

• 38mm tea light (If you have a slightly bigger tea light, send me a message and i will give you a modified version.)
• Glue
• White PLA
• Grey PLA (other colors possible)

Assembly:

• Push the tea light in the “38mm RING”. If the tea light is to loose use some tape around the edge of the light to make the fit a bit tighter.
• Push the assembly “38mm RING” + Tea light in the lightbulb.
• Add some drops of glue in the slot of the “Fitting” where the lightbulb needs to go in.
• Done! (Don’t forget to leave a picture of your results!)