Pikachu and Raichu Love Portrait (HueForge) by Big Simi

Big Simi

Generative 3D Model>Hueforge & Lithophane

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.08mm layer, 3 walls, 100% infill

Designer

3.2 h

1 plate

4.0(2)

Scaled for A1Mini, 0.08mm layer, 3 walls, 100% infill

2.8 h

1 plate

Boost

Released

Description

I create this image using HueForge and I use:

Filaments Used:
PLA BambuLab Basic Black
PLA BambuLab Basic Red
PLA BambuLab Basic Yellow
PLA BambuLab Basic Jade White

I hope everyone likes this and gives it ⭐⭐⭐⭐⭐!

Credits: https://www.pinterest.it/pin/838584393142764198/

Comment & Rating (6)

@Twinkletoes

Print Profile

0.08mm layer, 3 walls, 100% infill

came out great. I had to tweak the speed settings a little bit though.

Bed Adhesion Issue:simply slow down the print.

The designer has replied

@BigSimi

I'm Sorry for your issue but the bed Adhesion Is not a problem of the print profile

@sergiorojo3d

The model is beautiful. I have scaled it in X and Y but I have kept its size in Z to print it on an A1 Mini and the result has been great. I think it looks better if you use two shades of yellow, one lighter than the other, than if you use yellow and white.

The designer has replied

@BigSimi

Thank you very much for the suggestion! In the upcoming models, I will use your advice! If you really enjoyed this Hueforge, could you give it a rating?

@sergiorojo3d

Replying to @BigSimi :

Sorry, I can't. The only way to rate is directly print your profile, and I didn't. As I said, I needed to modificate it to fit on my printer.

@sergiorojo3d

Print Profile

0.08mm layer, 3 walls, 100% infill