Charmander, Charmeleon, Charizard Evolve Light Box by Tri-3D

Tri-3D

Generative 3D Model>Hueforge & Lithophane

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

Version 2, Updated Base 0.2mm layer, 2 walls, 15% infill

Designer

5.1 h

2 plates

4.3(3)

Boost

Released

Description

Charmander Evolved Light Box!

When I print light boxes I print without AUX cooling to prevent warping and lifting from the plate.

Colors used:
Bambu PLA Orange
Gratkit Black
Gratkit Grey
Gratkit Red

For Commercial Rights To This Model:
https://www.patreon.com/Tri_3D

Comment & Rating (14)

@Ssgallen

9Love the file, but couldnt get it to sit right. Never changed any settings except to my printer. Opened today in studio from here Walls a little thin though

(Edited)

The designer has replied

@Tri3D

Did you turn off AUX cooling? iv printed a few and never had this issue. are the sides flat or warped?

@rachele819

Replying to @Tri3D :

I've printed a few times and can't get the pieces together correctly either

@Tri3D

Replying to @rachele819 :

where are the problem area's ill take a look tonight

@Mugen89K

I just printed this on my A1 and it came out very nice. However, I didn’t notice your note about not turning the fan on so it won’t quite fit perfectly in some difficult curved areas and my first layer isn’t so smooth so it’s streaky :/ awesome model though thank you for making it :)

The designer has replied

@Tri3D

Hey, Most of my designs are built around my collection os P1S's. So scaling down might cause some issues. I find on most light boxes areas with sharp points. I need to take a razer and knock off the edge to make them fit properly. I will look into making some for smaller build plates soon. Thanks for the comment, always looking to improve :)

@Mugen89K

thank you ! :)

@user_3540377514

Cuales son sus medidas??

The designer has replied

@Tri3D

sorry I'm only english

@user_3540377514

Replying to @Tri3D :

hahaha there are translators today, what are the measures??

@CasperSlim

Print Profile

Version 2, Updated Base 0.2mm layer, 2 walls, 15% infill

found the right foot doesn’t quite line up when trying to fit the front plate on but otherwise a good build

The designer has replied

@Tri3D

Hey, Could you please email me some photos tri-3d@proton.me Is this at 100% scale with my profile? Id like to improve the design so it works for everyone