The infamous CONE PIN CHALLENGE!
Copyright Claim
The infamous CONE PIN CHALLENGE!
Boost
9
13
21
Print Profile(1)
0.2mm layer, 1 walls, 0% infill
Designer
25 min
1 plate
Boost
9
13
21
0
104
72
Released
Description
This is a simple printer test and a fun challenge! Adjust your settings until your printer can handle it. Hope you like it! Thanks!
Comment & Rating (21)
All
Print Profile
0.2mm layer, 1 walls, 0% infill
Printed fine on X1, could probably go smaller to make it tougher tbh
1
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
worked perfectly.
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
Other Issues: I accidentally ran out of filament, but this test works so good
1
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
nice print
1
Reply
Thank you, I’m so glad it works and you like it!
1
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
The designer has replied
0
Reply
Why?
(Edited)1
Reply
Replying to @CarGuy5811
Thank you for your support!
(Edited)1
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
1
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
1
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
1
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
1
Reply
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld