Elemental Dragon HueForge (Lava or Ice)
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.08mm
Swap Instructions:
Start with Black
At layer #15 (1.2mm) swap to Red/Blue
At layer #20 (1.6mm) swap to Orange/Cyan
At layer #25 (2mm) swap to Yellow/White for the rest.
Attention!!! If you print the big model on the X1/X1C, you must remove the flow calibration lines.
____________________________________________________
HueForge Drago Elementale (Lava o Ghiaccio)
Stampa con riempimento al 100% con un'altezza dello strato di 0,08 mm con uno strato di base di 0,08 mm
Istruzioni per lo scambio:
Inizia con il Nero
Al livello #15 (1.2 mm) passa al Rosso/Blu
Al livello #20 (1.6 mm) passa all'Arancione/Azzurro
Allo strato #25 (2 mm) passa al Giallo/Bianco per il resto.
Attenzione!! Se stampi il modello grande sulla X1/X1C, rimuovi le linee di calibrazione del flusso.