Hat / Cap hooks, wall mount storage for your hats, cap holder
Boost
30
66
11
Print Profile(2)
0.16mm layer, 8 walls, 40% infill
2.5 h
1 plate
0.16mm layer, 8 walls, 40% infill
2.8 h
1 plate
Boost
30
66
11
1
116
89
Released
Description
A simple hat storage solution, holds 5 hats/caps, secure and easy to use.
Printed sideways and with no supports.
Comment & Rating (11)
All
Print Profile
0.16mm layer, 8 walls, 40% infill
The print profile I used was using supports where they were not needed and had the print laying on its back, I changed the profile to not use the supports and instead print on the side as instructed by the author. Now it's a clean and strong print. Thanks to the author for sharing the design!
(Edited)
1
Reply
Solid print but the design doesn't work well with multiple hats...there is too much overlap.
0
Reply
Boosted
Print Profile
0.16mm layer, 8 walls, 40% infill
0
Reply
Print Profile
0.16mm layer, 8 walls, 40% infill
0
Reply
Print Profile
0.16mm layer, 8 walls, 40% infill
0
Reply
Print Profile
0.16mm layer, 8 walls, 40% infill
0
Reply
Print Profile
0.16mm layer, 8 walls, 40% infill
0
Reply
Print Profile
0.16mm layer, 8 walls, 40% infill
0
Reply
Print Profile
0.16mm layer, 8 walls, 40% infill
0
Reply
Print Profile
0.16mm layer, 8 walls, 40% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld