Hueforge Piraten schiff auf offener See
Hueforge Piraten schiff auf offener See
Boost
25
40
8
Print Profile(1)
0.08mm layer, 2 walls, 100% infill
Designer
6 h
1 plate
Boost
25
40
8
0
69
15
Released
Description
es scheind das diese bild etwas zu hell ist
version 2 ist etwas dunkler
https://makerworld.com/en/models/168283
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA+ Sunlu Black Transmission Distance: 0.6
PLA+ Sunlu Grey Transmission Distance: 2
PLA+ Sunlu Silver Transmission Distance: 2
PLA+ Sunlu White Transmission Distance: 5
Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Grey
At layer #10 (0.88mm) swap to Silver
At layer #18 (1.52mm) swap to White for the rest.
Comment & Rating (8)
All
Print Profile
0.08mm layer, 2 walls, 100% infill
black is mostly washed out. is there a way to get more blacks?
The designer has replied
1
Reply
I'll check again🫣
(Edited)1
Reply
https://makerworld.com/en/models/168283
(Edited)1
Reply
Replying to @Fastfrosch
thanks. i will give it ago. i am a bit afraid it was my setting, as i imported the print i think it wanted to load a lightbox profile i had. i am not sure if i used that one before but it prompted me on the new one.
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
Printed Great
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
No more
© 2024 MakerWorld