As I put the final piece of the jnuk drawer together, I was glad the finishing piece was this project. It tackled some challenges and pushed me to learn and try using Fusion360 out of my normal realm.
Many versions and prints later and I am happy to say it works for my needs perfectly.
Check out my page for other holders that are shown in the photos. There are many versions of those as well and will continue to be posted.
The cutters used in this version posted are:
Please leabe feedback as always, I enjoy to constantly learn from any mistakes or suggestions.
Thank you.
PS: I superglued the sides together and used blue painters tape to hold them in place while it dried. I had to make some of the walls thinner to allow the rolls to fit.