Narex Wooden Screwdriver Mount - Wall or Skadis Peg Board - 7 Piece
This is my original design for the Narex 7-piece wooden screwdriver set, available here.
Wall Mount Details:
- 4mm holes for 6G screws.
- 9mm wide channel for screw bit.
- Two versions. Standard and countersunk screws.
- Screw centres 130mm apart
- Screws appx 20mm set back into the mount.
Skadis Pegboard Mount Options:
- Hook version and Skadis T-Nut system.
- T-Nut version is slightly wider so it can be centred and still fit the varied screwdriver sizes.
- T-nut design credit to @6d6178: link
- Requires 2 T-nuts from the link.
Print Setup:
- Recommended Material: PETG for added strength (especially for the hook version), although PLA will likely be fine.
- Wall mount versions can be oriented with the rear of the mount on the print bed.
- The T-nut version does not require supports. Orient these with the back of the mount at a 45-degree angle, face of the mount flat on the print bed.
- Hook version: Print with the base of the mount on the print bed and with supports.
- Layer Height: 0.2mm with 15% grid infill.
I designed this to fit specifically my set; leather gasket sizes in other sets may vary, I'm not sure.
I would appreciate feedback from anyone who prints.
Especially if you try it out on a different brand and it works :)
Thank you to all who choose to use and provide feedback on this design.
Your support and input is greatly appreciated.
Affiliate Link: Narex Wooden Handle Screwdriver Set 7-Pieces