Summarized from “TheRadScientist” on Thingiverse:

-----------------------------------------------------------------------------

The scared autocross cone (aka Skidward according to Blipshift, even though he clearly resembles Patrick, not Squidward).

He makes a great addition to an autocross course, RC track, crawler course, garage, car show, construction site, etc. 

Printing:
- Both the cone and the base print standing up, support free if using PLA. 

- Use support on the mouth of the cone when printing out of TPU.
- No support required for the tongue.
- Use support for Eyes.

- Tongue requires no support.

Assembly:

The parts will fit together without any glue, just press the parts together. Apply some superglue to the tongue to prevent it from popping out. The cone should pop into the base, you may need to squeeze the cone a bit around the edges to get it to pop in.

All Credit to: https://www.thingiverse.com/thing:3984002