spool drying box (SUNLU FILAMENT DRYER S1 S2 S4 )
Copyright Claim
spool drying box (SUNLU FILAMENT DRYER S1 S2 S4 )
Boost
14
35
9
GIF
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
9.6 h
1 plate
Boost
14
35
9
0
67
25
Released
Description
Special appearance design, can be loaded with silica and can be loaded inside AMS to dry Filament
Can be directly taken out and loaded into SUNLU FILAMENT DRYER S1, S2 and S4 and other drying machines.
The discharge port is designed at a special angle for easy pouring of silica without overflowing.
Integrated design requires no assembly or support
Comment & Rating (9)
All
Print Profile
0.2mm layer, 2 walls, 10% infill
Holes are too big so use compensation to make them smaller (unless you want to have debris filter), cap is to small make it 101% - I wish i knew that before printing other than that prints fine,works fine. In abs.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
nice
0
Reply
Which type of filament did you use?
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
excellent
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld