Speed Printing profile, CHT Nozzle / High Flow nozzle SpeedBoatRace Remixed by axelstechniccorner

Remixed by

axelstechniccorner

3D Printer>Test Models

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

0.25mm layer, 2 walls, 10% infill

Designer

20 min

1 plate

4.4(10)

Boost

148

Released

Description

My Plan was to Create a High Speed Printer Profile,

because the normal “sport and ludicrous” mode often doesn't give me the desired Result.

The profile is for both. The Standart Bambulab Nozzle and for the aftermarket High Flow Hotends.

If you want to use the normal Nozzle, please use the normal Pla Setting from Bambulab (21mm3/s)

The flow test reach in my three tests, a little bit over 32mm3/s. To get a little bit of safety, i set it to “only 30mm3/s”

The Settings are made for Bambulab Pla Basic Yellow.

Other materials I will add in the future

The hotend I used:

V1.25 Bi-Metall-Heatbreak-Hotend-Kit für Bambu Lab x1 x1 Carbon-Düse aus gehärtetem Stahl für Bambus-Bauch tücher p1p p1s hotend - AliExpress

A High flow hotend form a other Factory:

E3D High Flow ObXidian™ HotEnd for Bambu Lab X1/P1 Series (e3d-online.com) (I didn't own so far, but if I can order a E3D High Flow I will test it in the Future.)

The profile can be used for all objects. but then I would change the infill to gyroid or grid.

For even better quality, I would reduce the layer height. 0.2mm or 0.15mm. This means that you are still clearly superior to the standard profile and save a lot of time

I would be very happy for a like, comment or a positive rating.

If you have any problems, please describe the problem.

Future plans:

I want to try a benchy with a Bambulab for under 10 min. But first I'll see how the profile is received by you.

Comment & Rating (14)

@djcatnip

Print Profile

0.25mm layer, 2 walls, 10% infill

pretty great profile, used it with standard nozzle that came with my p1s and printed in 14m 5s with Voxel High speed pla pro, that can do 30mm3/s . The front edge is a bit off on the white boat but everything else turned out great. The orange boat is everything stock with Bambu Basic pla

@yobtnirp3D

Print Profile

0.25mm layer, 2 walls, 10% infill

The designer has replied

@axelstechniccor

hey, did you have any problems or issues with the print ?

@yobtnirp3D

Replying to @axelstechniccor :

took longer than expected, otherwise it was fine

@axelstechniccor

Replying to @yobtnirp3D :

did you use the same settings? even for the Filament (30mm3/s) ?

@RevelRob

Print Profile

0.25mm layer, 2 walls, 10% infill

pretty good for speed prints. I used it as a learning tool to figure out how to achieve certain speeds with some objects that need it with my CHT nozzle. thanks!