Print Profile(3)
Original P1
Designer
15.1 h
6 plates
Original A1
Designer
16.7 h
6 plates
A1 mini version
Designer
14.6 h
7 plates
Boost
30
53
24
0
56
70
Released
Description
Lamp is made from the bambu LED kit 001.
-No Supports needed.
-No brim needed.
-No mods to light kit required.
-All parts printed
Only needs the 2 screws that came with the LED kit 001.
https://us.store.bambulab.com/products/led-lamp-kit-001
Comment & Rating (24)
All
The piece in the middle of this photo looks to be split into two pieces. However, that piece in the print profiles seems to be one solid piece. Can you help me understand this?
The designer has replied
0
Reply
it is two pieces. it has a dovetail slide lock. to allow it to go around the cable.
0
Reply
Replying to @TKB3D
I assumed this is what was intended, but the piece in both print profiles does not have this dovetail.
0
Reply
ok I will look at it, may have uploaded wrong file
0
Reply
After finally getting around to assembly, the light switch is not far enough down in the light kit wire to go to the base, it goes halfway to the second arm of the lamp so this model is outdated now
The designer has replied
0
Reply
I didn't know they redesigned the kit. I will order the new version and see if I can make adjustments.
0
Reply
Replying to @TKB3D
yes so the length of the cord was probable the same, but the switch is now about in the middle of the wire now where it seems in your model, the switch was more towards the usb part of the wire
0
Reply
Replying to @PrintThisNThat
so I order two light kits and they are the same and fit the print. are you in the US maybe they are different in another country?
0
Reply
Is there a way to print this in A1 Mini? Tried printing in A1 mini but seems like some pieces are out of the plate :( Don't know how to fix that and not mess up other measurement.
The designer has replied
0
Reply
The arms are to long for the mini. it works need to be modified in Autocad. I may try and do that for you. if I can get it to work I will ket you know.
1
Reply
@SirBranson I modified the arms to be 8 mm shorter to fit the A1 mini bed. Use the new profile I made labeled "A1 mini." You will need to print two of each of the arm halves.
(Edited)1
Reply
Replying to @TKB3D
THANKS A lot FOR THE EFFORT!
1
Reply
Print Profile
Original P1
had to flip rotation for the head of the lamp where light goes to do with no supports but once i did that it printed flawlessly
The designer has replied
0
Reply
Thabks for rating glade tou like it. I will look in to the orientation.
0
Reply
Replying to @TKB3D
Standard orientation how you have it is with the little holes up towards the nozzle, but I flipped it so those are on the plate. In your pictures you can see you had the holes of it on the base plate because you can see the textured plate design
0
Reply
Print Profile
Original P1
nice!
The designer has replied
0
Reply
thanks for the comments and rating😁
0
Reply
Print Profile
Original P1
I really Liked the Light. Good print, had to turn the bell over on the plate to print without supports. Also sucks that Bambu changed the design of the 001 light kit so that the switch no longer reaches the base.
The designer has replied
0
Reply
thanks for the comments, glad you like it.
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld